That I do not know.
I will talk to Garrett about getting it tested.
Thanks,
Jenn
From: Hassan Ibrahim [mailto:hai@curran-mcleod.com]
Sent: Tuesday, September 16, 2014 9:20 AM
To: 'Jennifer Cline'
Cc: 'Dan Huff'; 'Garrett Edmunds'
Subject: RE: New stamped water line plan
Hi Jenn,
I believe the referenced site is correct, the design engineer needs to submit construction plans, plan review fee and LUCS and obtain approval from OHA.
As far as item 3 below, I would recommend using 6”x8” reducer and upsize the new section to 8” diameter. Is there enough fire flow or has a flow test been done on the 6” line to meet fire flow demands of 1,500 gpm?
Regards,
--------------------
Hassan Ibrahim, P.E.
CURRAN-McLEOD, INC.
6655 SW Hampton St, Ste. 210
Portland, OR 97223
Tel: 503-684-3478
Fax: 503-624-8247
Cell: 503-807-2737
email: hai@curran-mcleod.com
From: Jennifer Cline [mailto:jcline@cityofmolalla.com]
Sent: Tuesday, September 16, 2014 8:57 AM
Cc: Dan Huff; Garrett Edmunds
Subject: RE: New stamped water line plan
Hi Hassan,
See my answers below in RED.
Also, Regarding the Oregon Health Authority, is the link below correct for direction on how to about getting approval?
Thanks,
JC
From: Hassan Ibrahim [mailto:hai@curran-mcleod.com]
Sent: Monday, September 15, 2014 2:27 PM
To: 'Jennifer Cline'
Cc: 'Garrett Edmunds'; 'Dan Huff'
Subject: RE: New stamped water line plan
Hi Jenn,
Here is my comments:
1. I thought part of this line already exists? According to the plans they are constructing the entire run. The phase 1 portion of the line does already exist.
2. Prior to construction, they need approval of the plans from Oregon Health Authority. Will include comment.
3. I would not allow a pipe less than 8” in diameter regardless. The existing line is already 6”, I’m not sure what else can be done at this point
4. If existing easement isn’t in place, then a new 15’ wide waterline easement needs to be dedicated to the City. City needs to review the easement document prior to recordation. I agree, working on this
5. All pipe restraints shall be mechanical, no thrust blocks are allowed. No thrust blocks have been included in the design, however I will note that.
6. Fire department should comment on the plans. Will forward plans
7. Fire hydrant detail should be included on the plans. Will include the comment.
8. They show a water service detail but where are they proposing the installation, Garrett doesn’t like to use copper tubing on the services. I will request more info.
Please let me know if you have any questions.
--------------------
Hassan Ibrahim, P.E.
CURRAN-McLEOD, INC.
6655 SW Hampton St, Ste. 210
Portland, OR 97223
Tel: 503-684-3478
Fax: 503-624-8247
Cell: 503-807-2737
email: hai@curran-mcleod.com
From: Jennifer Cline [mailto:jcline@cityofmolalla.com]
Sent: Monday, September 15, 2014 1:05 PM
Cc: Garrett Edmunds; Dan Huff
Subject: FW: New stamped water line plan
Hi Hassan,
Looks like they were working on this after all. Any comments?
Jenn
From: Mitch Jorgensen [mailto:mjj@molalla.net]
Sent: Friday, September 12, 2014 4:38 PM
To: 'Jennifer Cline'
Subject: New stamped water line plan
Here it is. Please submit to your engineering. Thanks
Mitch Jorgensen, Pres.
QCT/CCT #44362
Molalla Redi-Mix & Rock Products, Inc.
PO Box 555
Molalla, Or 97038
(503) 829-5555 x 15 office
(503) 829-5558 fax
(503) 969-3377 cell
Online at molallaredimix.com