Credit application sent out earlier today. Should have a signed PO in a few emailed to you.
Regards,
Gerald Fisher, P.E. | Public Works Director
City of Molalla
117 N Molalla Ave. | PO Box 248 |Molalla, OR 97038
Office: 503.829.6855 | Direct: 503.759.0218
CONFIDENTIALITY NOTICE: The information contained in this email message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient and have received this communication in error, please contact the sender by reply email and destroy all copies of the original message. Thank you.
From: Tim Owens [mailto:timo@correctequipment.com]
Sent: Friday, August 12, 2016 11:16 AM
To: gfisher@cityofmolalla.com
Cc: Crystal Hudson <crystalh@correctequipment.com>
Subject: RE: Flow Meter
Gerald,
I had you email misspelled last time, see below and the attached.
Best Regards,
Tim Owens || Sales Rep
Office: 503.582.0555
Cell: 503.616.8279
Fax: 971.223.2975
From: Tim Owens
Sent: Friday, August 12, 2016 11:12 AM
To: jclifford@cityofmolalla.com
Cc: 'gfischer@cityofmolalla.com'; Crystal Hudson
Subject: Flow Meter
Jason,
See the attached flow meter quote. The purchase order will need to be made out to ABB/CO Correct Equipment, note that freight is not included. I will need the credit application filled out and returned to Crystal and myself along with the purchase order and then we will process.
A couple of things. We need to ensure that this pipe is always full and I want to make sure that the installation also includes an air relief valve (it wasn’t included and it should be, supplied by McClure) at the high point. Secondly we would want to see the meter as far away from the 45 elbow as possible. We don’t expect much interference from these and should see roughly 1% error or less being right next to it. Lastly, we would want to make sure that the electrodes of the flow meter are not in line with the bend and should be on the sides so they pick up the laminar flow.
Please let me know if you have questions but we should move on this very quickly.
Best Regards,
Tim Owens || Sales Rep
300 S. Redwood Street, Suite 135
Canby, OR 97013
Office: 503.582.0555
Cell: 503.616.8279
Fax: 971.223.2975