From: VICK Nicole R.
Sent: Thu Sep 01 13:53:58 2011
To: EBERSOLE Gerald
Subject: RE: OAR 228-0639
Importance: Normal
Oh, that makes sense. OK, I’ll forward that on as:
(5) Determine the concentration of pollutants in the fuel (mercury, chlorine, and/or total selected metals) in units of pounds per million Btu of each composite sample for each fuel type according to the procedures in Table 4, Fuel Analysis Requirements.
Since a table referenced within a rule without an OAR attached implies it belongs to that division, it’s safe to leave off “to this Division”.
Thanks for clarifying, Jerry!
From: EBERSOLE Gerald
Sent: Thursday, September 01, 2011 1:51 PM
To: VICK Nicole R.
Subject: RE: OAR 228-0639
Our Table 4 is Table 6 in the underlying federal rule. I just forgot to make the correction when I pulled the language into our rules. In addition, to come up with the concentration in lbs/MMBtu, you would use #6 and #7 in Table 4.
From: VICK Nicole R.
Sent: Thursday, September 01, 2011 1:36 PM
To: EBERSOLE Gerald
Subject: RE: OAR 228-0639
Ok, so you would prefer to refer to the entire table rather than the specific line #6 of table 4 that determines the concentration of pollution (mercury) in the fuel? I only want to be sure so we don’t have to send a correction on a correction and Table 4 covers entire fuel analysis requirements, while this specific rule 228-0639(5) seems to refer specifically to line #6.
Would you mind triple checking? Sorry…
From: EBERSOLE Gerald
Sent: Thursday, September 01, 2011 1:28 PM
To: VICK Nicole R.
Subject: RE: OAR 228-0639
It should be "Table 4 to this Division".
From: EBERSOLE Gerald
Sent: Thursday, September 01, 2011 1:03 PM
To: VICK Nicole R.
Subject: RE: OAR 228-0639
I think it should say Table 4 to this division, but I would have to verify. It may take me a while to track down the federal rule that was used for this rule.
From: VICK Nicole R.
Sent: Thursday, September 01, 2011 12:38 PM
To: EBERSOLE Gerald
Subject: OAR 228-0639
Good afternoon, Jerry-
Under OAR 340-228-0639(5), Table 6 is referenced. I cannot locate a Table 6 and I think this actually refers to line #6 on Table 4. Would you mind reviewing this please and confirming this for me please before I send off for an administrative correction?
If this is a mistake, is the following wording acceptable:
(5) Determine the concentration of pollutants in the fuel (mercury, chlorine, and/or total selected metals) in units of pounds per million Btu of each composite sample for each fuel type according to the procedures in Table 4, 6 to this subpart 6, Fuel Analysis Requirements.
Please let me know if this is ok or make any revisions.
Thanks!
Nicole Vick
Air Quality Program Analyst
Oregon Department of Environmental Quality
503-229-5946
P Please consider if it is necessary to print this e-mail